P-TECH IT
All P-TECH sites online· 9:16 PM Eastern, open the status page

Lesson 1: Mobile Devices

CompTIA A+ Core 1 (220-1201) · Objectives 220-1201 1.1, 220-1201 1.2, 220-1201 1.3 · Download .docx

Objectives

Key terms

Laptop battery
Rechargeable lithium-ion or lithium-polymer power pack inside a portable device; capacity fades with charge cycles and it must be replaced with an exact compatible part.
USB
Universal Serial Bus: industry standard for connecting, powering and transferring data between devices and peripherals through hot-swappable ports and cables.
Cellular data
Internet access delivered through a mobile carrier's radio network, which can be enabled or disabled per device or per app to control usage.
Laptop keyboard replacement
Swapping a portable computer's built-in keyboard, often by releasing clips or screws and disconnecting a ribbon cable from the motherboard connector.
USB-C
Small, reversible 24-pin connector that can carry USB data, video, network and high-wattage power delivery over a single cable.
3G
Third generation of mobile network technology offering early mobile broadband speeds of a few Mbps; most carriers have now shut it down.
RAM
Random-access memory: fast, volatile working memory that holds running programs and data; its contents are lost when power is removed.
MicroUSB
Small, non-reversible trapezoid-shaped USB connector that was common on older Android phones, cameras and accessories before USB-C.
4G
Fourth generation of mobile networks, mainly LTE, providing all-IP mobile broadband with typical speeds of tens of Mbps.
HDD
Hard disk drive: storage device that records data magnetically on spinning platters read by a moving actuator arm and heads.
MiniUSB
Older, slightly larger five-pin USB connector, predating micro-USB, found on legacy cameras, GPS units and game controllers.
5G
Fifth generation of mobile networks offering much higher speeds, lower latency and more connected devices, using low-band, mid-band and millimeter-wave spectrum.
SSD
Solid-state drive: storage device that keeps data in NAND flash memory chips with no moving parts, making it faster, quieter and more shock-resistant than a hard disk.
Lightning
Apple's proprietary reversible eight-pin connector for charging and data on older Apple phones and tablets; newer models switched to USB-C.
LTE
Long-Term Evolution: the main 4G cellular standard, an all-IP mobile broadband technology that replaced 3G networks.

The concept

220-1201 1.1 — Monitor mobile device hardware and choose the right replacement and upgrade techniques (batteries, memory, storage, biometrics). Laptop SO-DIMM location: Letter B marks the SO-DIMM (small outline DIMM) memory modules. Laptops use SO-DIMMs, which are roughly half the length of desktop DIMMs; when memory is not soldered to the system board, a memory upgrade means replacing or adding SO-DIMMs of the DDR generation the board supports. Wi-Fi antenna leads after repair: Laptop Wi-Fi antennas are usually routed through the display lid, and their thin coaxial leads snap onto the MAIN and AUX terminals of the M.2 wireless card (Letter D). Replacing the display requires disconnecting and rerouting those leads, so a loose, swapped or pinched lead is the most likely cause of a sudden drop in signal strength. CMOS/RTC battery failure: Letter G is the CMOS/RTC coin-cell battery. It powers the real-time clock and keeps firmware settings whenever no other power source is available, so a failed coin cell shows up only after the main battery is fully drained and the AC adapter is disconnected. Swollen lithium-ion battery: A bulging case and a touchpad that will not click are classic signs of a swollen lithium-ion battery pushing on the parts above it. Swelling means internal gas buildup and a fire risk, so the technician stops charging, powers the laptop off and removes the pack without bending or puncturing it, then stores it in a fire-safe container and sends it to an approved lithium-ion battery recycler rather than the trash. Battery health calculation: Battery health is full charge capacity divided by design capacity: 22,400 ÷ 56,000 = 0.40, or 40%. The pack now stores only 40% of the energy it held when new, which matches the shortened runtime. Riveted keyboard replacement: When a keyboard is riveted or heat-staked to the palm rest, the manufacturer supplies the two as one field-replaceable unit, so the technician swaps the whole top-cover assembly. Liquid damage usually affects the keyboard's membrane layers beneath the keys, which new key caps or software cannot repair.

220-1201 1.2 — Compare accessories and connection options for mobile devices (ports, docks, Bluetooth, NFC, hotspots, webcams). USB-C capabilities: USB Type-C is a 24-pin reversible connector. With USB Power Delivery 3.1 Extended Power Range it can supply up to 240 W, and its alternate modes let the same port carry DisplayPort or Thunderbolt signals, which is why one cable can charge a laptop and drive monitors. Lightning connector: Lightning is a proprietary, reversible 8-pin connector that older iOS devices used for charging and data; the other end of the cable is usually USB-A or USB-C. Newer iOS devices have moved to USB-C, so a mixed fleet often needs both cable types. miniUSB legacy devices: miniUSB (Mini-B) was common on cameras, GPS units and media players before microUSB replaced it. It is thicker than microUSB and non-reversible, so a USB-A-to-miniUSB cable connects the unit to a PC for data transfer and charging. USB-C charger wattage: USB-C chargers and devices use USB Power Delivery (PD) to negotiate voltage and current. A 20 W phone charger cannot keep up with a laptop that typically needs 45–100 W, so the laptop draws what it can and warns that charging is slow. NFC short range: NFC operates at 13.56 MHz over a range of roughly 4 cm or less, so a transaction happens only when the user deliberately holds the phone to the reader. That short range, combined with payment tokenization and device authentication, makes accidental or long-distance interception far harder than with longer-range radios. Wired headset on USB-C phone: Phones without a headphone jack send digital audio over USB-C. A USB-C to 3.5 mm adapter containing a digital-to-analog converter (DAC) converts that signal so an analog wired headset, including its microphone, works with no pairing at all.

220-1201 1.3 — Configure mobile device network connectivity and application support (Wi-Fi, cellular, sync, MDM, BYOD). Airplane mode with Wi-Fi: Airplane mode turns off all radios, including cellular voice and data. Current phones let the user re-enable Wi-Fi (and Bluetooth) individually while airplane mode stays on, so the cellular radio remains off while the device uses the aircraft's Wi-Fi. Data cap and cloud sync: Cloud storage and photo backup apps upload large files in the background. Restricting them to Wi-Fi (or turning off cellular data for that app) stops them from consuming a capped cellular plan while still backing up whenever the phone is on Wi-Fi. eSIM activation: An eSIM is an embedded, reprogrammable SIM. Instead of inserting a card, the user downloads a carrier profile, commonly by scanning a QR code or using the carrier's app, which provisions the phone number and network credentials on the device. Preferred network type: Repeatedly searching for and switching to a weak 5G signal consumes significant radio power. Limiting the preferred network type to 4G/LTE keeps a stable data connection and cuts that overhead. Securing a mobile hotspot: A hotspot is a small Wi-Fi access point, so its passphrase controls who can join. Setting a new, strong passphrase with WPA3 (or WPA2/WPA3 transition mode for older laptops) disconnects devices that knew the old one, and she then reconnects only her laptop. Bluetooth pairing order: Each step depends on the one before it: the tablet's radio must be on, the scanner must be discoverable (pairing mode) before the tablet can find it, the PIN or passkey is requested only after the device is selected, and a test confirms the pairing actually works. This matches the A+ sequence: enable Bluetooth, enable pairing, find a device, enter the PIN, test connectivity.

Worked examples

Example 1: A laptop has two SO-DIMM slots. One holds an 8 GB DDR4-3200 module and the other is empty. The user wants 16 GB of RAM running in dual-channel mode at the lowest cost. What should the technician install? Answer: A second 8 GB DDR4-3200 SO-DIMM in the empty slot. Dual-channel operation needs a module in each channel, ideally matched in capacity, generation and speed. Adding a second 8 GB DDR4-3200 SO-DIMM reaches 16 GB, populates both channels and reuses the existing module, so it is also the cheapest option. DDR generations are keyed differently and are not interchangeable, and laptops use the short SO-DIMM form factor.
Example 2: A teacher pairs a portable Bluetooth speaker with her phone, and the phone lists the speaker as connected. When she plays a video, the sound still comes from the phone's own speaker. What should the technician do? Answer: Select the Bluetooth speaker as the audio output device. Pairing and connecting a Bluetooth speaker does not always make it the active audio device; the phone's media output selector (or the speaker's media audio profile toggle) determines where sound plays. Choosing the speaker as the output sends audio over the Bluetooth A2DP link to the accessory.
Example 3: Location services are on for a field technician's phone, and the map app shows her position correctly. However, the company's dispatch app reports 'location unavailable.' What should the technician check next? Answer: The dispatch app's location permission setting. Because another app gets an accurate location, the GPS hardware and system-wide location services are working. Mobile operating systems also grant location access per app (for example Never, Ask, While Using or Always), so the dispatch app has most likely been denied or limited. Setting it to 'While using the app,' or 'Always' if the business needs background tracking, fixes the issue.

Common mistakes

Self-check

Try each one before you look. A miss here costs nothing and tells you exactly what to reread.

1. Refer to the exhibit. A technician is upgrading this laptop's memory from 8 GB to 16 GB. Which lettered component will the technician replace or add to?
2. A staff member's laptop has no built-in camera. He needs a camera for daily video meetings that he can clip onto the external monitor at his desk. Which accessory is the simplest fit?
3. A delivery app shows a driver's location accurately on the street, but inside a large concrete warehouse the location jumps around and is off by several hundred meters. What best explains this?
4. A laptop that once ran 8 hours on battery now lasts about 3. Its Windows battery report lists a design capacity of 56,000 mWh and a full charge capacity of 22,400 mWh. What is the battery's health, and what is the appropriate action?
5. A technician must connect a legacy handheld GPS unit to a PC to update its maps. The unit's port is non-reversible and noticeably thicker than the microUSB ports on older phones, and a microUSB cable will not fit. Which cable should the technician use?

Canvas is the official record. This companion enhances the PGCC curriculum; it does not replace it. Last name and class year only. Students with a 504 plan or IEP: your accommodations apply.

← All notesLesson 2: Networking Fundamentals: Ports, Hardware and Connections →

↑ Back to top